Mesh Analysis

Reference

Mode:

Edit Mode

Panel:

Header ‣ Overlays ‣ Mesh Analysis

Mesh analysis is useful for displaying attributes of the mesh, that may impact certain use cases.

The mesh analysis works in Edit Mode and Solid Viewport shading. It shows areas with a high value in red, and areas with a low value in blue. Geometry outside the range is displayed gray.

Currently the different modes target 3D printing as their primary use.

Overhang

Extrusion 3D printers have a physical limit to the overhang that can be printed, this display mode shows the overhang with angle range and axis selection.

Minimum/Maximum

Minimum/Maximum angle to display.

Axis

Axis and direction to use as the bases to calculate the angle to visualize.

Thickness

Printers have a limited wall-thickness where very thin areas cannot be printed, this test uses ray casting and a distance range to the thickness of the geometry.

Minimum/Maximum

Minimum/Maximum thickness to display.

Samples

Number of samples to use to calculate the thickness.

Intersections

Another common cause of problems for printing are intersections between surfaces, where the inside/outside of a model cannot be reliably detected.

Unlike other display modes, intersections have no variance and are either on or off.

Distortion

Distorted geometry can cause problems since the triangulation of a distorted n-gon is undefined.

Distortion is measured by faces which are not flat, with parts of the face pointing in different directions.

Minimum/Maximum

Minimum/Maximum distortion to display.

Sharp Edges

Similar to wall-thickness, sharp edges can form shapes that are too thin to be able to print.

Minimum/Maximum

Minimum/Maximum angle to display.

Known Limitations

There are some known limitations with mesh analysis:

• Currently only displayed with Deform Modifiers.

• For high-poly meshes the performance is low while editing.