Draw

Reference

Mode:

Edit Mode

Tool:

Toolbar ‣ Draw

The Curve draw tool allows you to free-hand draw curves.

Tool Settings

Type

Type of curve to use for drawing.

• Poly:

  Bézier Curve with straight line segments (auto handles).

  Bézier:

  • Tolerance

    Lower values give a result that is closer to the drawing stroke, while higher values give more smoothed results.

    Method

    Refit:

    Incrementally refits the curve (gives best results).

    Split:

    Splits the curve until the tolerance is met (gives a better drawing performance).

    Detect Corners

    Detects corners while drawing based on a specified angle; Any angles above the specified value are considered corners. If a corner is detected, the curve uses non-aligned handles for the corner resulting in a more crisp corner.

Taper Start, End

Taper factor for the radius of the start and end points along the curve.

Radius Min

Minimum radius when the minimum pressure is applied (also the minimum when tapering).

Max

Radius to use when the maximum pressure is applied (or when a tablet is not used).

Use Pressure

Uses stylus pressure to control the radius of the curve.

Depth

Controls where and how the curves are drawn.

• Cursor:

  Uses the depth under the cursor to draw curves.

  Surface:

  Used to draw on top of other objects.

  • Project Onto Selected

    Only project the strokes onto selected objects.

    Offset

    Distance to offset the curve from the surface.

    Absolute Offset

    Applies a fixed offset (does not scale by the curve radius).

    Only First

    Only uses the start of the stroke for the depth.

    Plane

    The orientation plane to draw on, available when Only First is enabled.

    Normal to Surface:

    Draws aligned to the surface.

    Tangent to Surface:

    Draws perpendicular to the surface.

    View:

    Draws aligned to the viewport.

Options

After the tool is run, these options are available in the Adjust Last Operation panel.

Error

Error distance in object units. This can be seen similar to a subdivision rate for the curve. Lower values give a result that is closer to the drawing stroke while higher values give more smoothed results.

Fit Method

• Refit:

  Incrementally refits the curve (gives best results).

  Split:

  Splits the curve until the tolerance is met (gives a better drawing performance).

Corner Angle

Any angles above this are considered corners.

Cyclic

Toggles whether or not the curve is Cyclic.