Traxxas Stampede VXL

This vehicle was chosen to understand how a Pixhawk could be used for wheeled platforms. We chose to use a Traxxas vehicle as they are very popular and it is a very strong brand in the RC community. The idea was to develop a platform that allows for easy control of wheeled UGVs with an autopilot.

{% youtube %}https://youtu.be/N3HvSKS3nCw{% endyoutube %}

Traxxas Stampede VXL

Parts List

Assembly

The assembly consists of a wooden frame on which all the autopilot parts were attached. Tests showed that a better vibration insulation should be used, especially for the Pixhawk and the Flow module.

Stampede Chassis

Wooden Panel Top

Wooden Panel Bottom

Traxxas Stampede Final Assembly

Side View Final Assembly

Wodden panel fixture

For this particular mounting we chose to use the clip supplied with the rover to attach the upper plate. For this, two supports were 3D printed. The CAD files are provided here.

Warning It is HIGHLY RECOMMENDED to set the ESC in training mode (see Traxxas Stampede Manual) so to reduce the power to 50%.

Output Connections

PWM Output Actuator
MAIN2 Steering servo
MAIN4 ESC input

Note As documented in the Airframe reference here.

配置

Rovers are configured using QGroundControl in the same way as any other vehicle.

The main rover-specific configuration is setting the correct frame:

  1. Switch to the Basic Configuration section in QGroundControl
  2. Select the Airframe tab.
  3. Scroll down the list to find the Rover icon.
  4. Choose Traxxas stampede vxl 2wd from the drop down list.

选择机架

用法

At the current time, PX4 only supports MISSION and MANUAL modes when a RC remote is connected. To use the mission mode, first upload a new mission to the vehicle with QGC. Then, BEFORE ARMING, select MISSION and then arm.

Warning It is VERY IMPORTANT to do a mission composed ONLY of normal waypoints (i.e. NO TAKEOFF WAYPOINTS) and it is crucial to SET THE WAYPOINT HEIGHT OF EVERY WAYPOINT TO 0 for a correct execution. Failing to do so will cause the rover to continuously spin around a waypoint.

A correct mission setup looks as follows:

mission