Set up a Minikube cluster

How to setup a Minikube cluster

前期准备

Install:
For Windows:
- Enable Virtualization in BIOS
- Install Hyper-V

Note

See the official Minikube documentation on drivers for details on supported drivers and how to install plugins.

Start the Minikube cluster

If applicable for your project, set the default VM.
```
minikube config set vm-driver [driver_name]
```
Start the cluster. If necessary, specify version 1.13.x or newer of Kubernetes with --kubernetes-version
```
minikube start --cpus=4 --memory=4096
```

Enable the Minikube dashboard and ingress add-ons.

# Enable dashboard
minikube addons enable dashboard
# Enable ingress
minikube addons enable ingress

Install Helm v3 (optional)

If you are using Helm, install the Helm v3 client.

Important

The latest Dapr Helm chart no longer supports Helm v2. Migrate from Helm v2 to Helm v3.

Troubleshooting

The external IP address of load balancer is not shown from kubectl get svc.

In Minikube, EXTERNAL-IP in kubectl get svc shows <pending> state for your service. In this case, you can run minikube service [service_name] to open your service without external IP address.

$ kubectl get svc
NAME                        TYPE           CLUSTER-IP       EXTERNAL-IP   PORT(S)            AGE
...
calculator-front-end        LoadBalancer   10.103.98.37     <pending>     80:30534/TCP       25h
calculator-front-end-dapr   ClusterIP      10.107.128.226   <none>        80/TCP,50001/TCP   25h
...
$ minikube service calculator-front-end
|-----------|----------------------|-------------|---------------------------|
| NAMESPACE |         NAME         | TARGET PORT |            URL            |
|-----------|----------------------|-------------|---------------------------|
| default   | calculator-front-end |             | http://192.168.64.7:30534 |
|-----------|----------------------|-------------|---------------------------|
🎉  Opening kubernetes service  default/calculator-front-end in default browser...

Minikube