2D Joint

The physics system contains a series of joint components for connecting two rigid bodies. Joint components can be used to simulate the interaction between real-world objects such as hinges, pistons, ropes, wheels, pulleys, motor vehicles, chains, etc. Learning how to use joint components can create a realistic and interesting scenario.

Note.

1. Joint components are not available in the Builtin 2D physics module.

2. Joint components are required with rigid body to work correctly. As shown in the following figure.

   

Adding joints

Click the Add Component button on the Inspector panel and enter the component name of the 2D joint.

Common Properties of Joints

Although each joint has different representations, they also share some common properties:

Each joint needs to connect two rigid bodies to perform its function. We consider the rigid body hanging under the same node of the joint as the joint’s home end, and ConnectedBody as the rigid body on the other end. Usually, each rigid body picks a location around itself and sets it as an anchor point. Depending on the type of joint component, the anchor point determines the center of rotation of the object, or a coordinate point used to maintain a certain distance, etc.

The CollideConnected property is used to determine whether the rigid bodies at the ends of the joints need to continue to follow the regular collision rules.

If you are now going to make a ragdoll, you might want the thighs and lower legs to partially overlap and then connect together at the knees, then you would set the CollideConnected property to false. If you are going to make a lift and want the lift platform and floor to collide, then you would set the CollideConnected property to true.

Adjusting Anchor Points

Anchor points can be adjusted in the scene by clicking and dragging the to adjust the Anchor property, and by to adjust the ConnectedAnchor.

DistanceJoint2D

Click Add Component on the Inspector panel and enter DistanceJoint2D to add a distance joint.

DistanceJoint constrains the rigid bodies at both ends of the joint to a maximum range. Beyond this range, the motion of the rigid bodies will interact with each other.

Below this range, they will not interact with each other.

Properties

FixedJoint2D

Click Add Component on the Inspector panel and enter FixedJoint2D to add a fixed joint.

Fixed Joint holds two points on two objects together based on their initial angles.

Properties

HingeJoint2D

Click Add Component on the Inspector panel and enter HingeJoint2D to add a hinge joint.

A Hinge Joint can be seen as a hinge or peg, where the rigid body rotates around a shared point.

Properties

When motor speed is enabled, the jointed rigid body will try to gradually accelerate to the desired speed.

RelativeJoint2D

Relative joints can be added by clicking Add Component on the Inspector panel and entering RelativeJoint2D.

Relative Joint controls the relative motion between two rigid bodies.

Properties

SliderJoint2D

Click Add Component on the Inspector panel and enter SliderJoint2D to add a sliding joint.

With a Slider Joint, the angle between the two rigid bodies is fixed and they can only slide on a specified axis. The blue square in the figure below is subject to gravity but can actually only move in the set direction due to the constraints of the joint.

Properties

SpringJoint2D

Click Add Component on the Inspector panel and enter SpringJoint2D to add a spring joint.

The Spring Joint connects objects at the ends of the joint like a spring.

Properties

WheelJoint2D

Click Add Component on the Inspector panel and enter WheelJoint2D to add a wheel joint.

The Wheel Joint is used to simulate the wheels of a motor vehicle.

Consider enabling EnableMotor for both front and rear wheels in the case of simulated realistic 4WD, and EnableMotor for only the drive wheels in the case of non-4WD. The illustration shows only the front wheels with EnableMotor enabled, thus simulating a front-wheel drive situation.

Properties