A Simple Plugin

This section describes how to write, compile, configure, and run a simple Traffic Server plugin. You’ll follow the steps below:

  1. Make sure that your plugin source code contains an TSPluginInit() initialization function.
  2. Compile your plugin source code, creating a shared library.
  3. Add an entry to plugin.config.
  4. Add the path to your plugin shared library into records.config.
  5. Restart Traffic Server.

Compile Your Plugin

The process for compiling a shared library varies with the platform used, so the Traffic Server API provides the tsxs tool which you can use to create shared libraries on all the supported Traffic Server platforms.

Example

Assuming the sample program is stored in the file hello_world.c, you could use the following commands to build a shared library:

  1. tsxs -o hello_world.so -c hello_world.c

tsxs is installed in the bin directory of Traffic Server.

This shared library will be your plugin. In order to install it, run:

  1. sudo tsxs -o hello_world.so -i

or the equivalent to sudo on your platform.

Update the plugin configuration file

Your next step is to tell Traffic Server about the plugin by adding the following line to plugin.config file. Since our simple plugin does not require any arguments, the following plugin.config will work:

  1. # a simple plugin.config for hello_world
  2. hello_world.so

Traffic Server can accommodate multiple plugins. If several plugin functions are triggered by the same event, then Traffic Server invokes each plugin’s function in the order each was defined in plugin.config.

Specify the Plugin’s Location

All plugins must be located in the directory specified by the configuration variable proxy.config.plugin.plugin_dir, which is located in the records.config file. The directory can be specified as an absolute or relative path.

If a relative path is used, then the starting directory will be the Traffic Server installation directory as specified in etc/traffic_server. The default value is libexec/trafficserver, but this can vary based on how the software was configured and built. It is common to use the default directory. Be sure to place the shared library hello_world.so inside the directory you’ve configured.

Restart Traffic Server

The last step is to start/restart Traffic Server. Shown below is the output displayed after you’ve created and loaded your hello_world plugin.

  1. # ls libexec/trafficserver
  2. hello_world.so*
  3. # bin/traffic_server
  4. [Mar 27 19:06:31.669] NOTE: updated diags config
  5. [Mar 27 19:06:31.680] NOTE: loading plugin 'libexec/trafficserver/hello_world.so'
  6. hello world
  7. [Mar 27 19:06:32.046] NOTE: cache disabled (initializing)
  8. [Mar 27 19:06:32.053] NOTE: cache enabled
  9. [Mar 27 19:06:32.526] NOTE: Traffic Server running

Note

In the example above, Traffic Server notes are directed to the console by specifying E for proxy.config.diags.output.note in records.config. The second note shows Traffic Server attempting to load the hello_world plugin. The third line of Traffic Server output is from your plugin.